3D-printed float for the remote This float attaches to the bottom of the remote and is bright orange for visibility when floating upside down.
I’ve been using this design for over 6 months and have never unintentionally dropped the remote in the surf. It’s perfect for sharing the remote with friends in the surf or for doing pump relays.
Installation:
The float is attached to the remote with the supplied M3 screw, and then secured with glue-lined heat shrink.
Important: It is critical that glue-lined heat shrink is used to secure the float properly. If you don’t have a way to shrink heat shrink tubing, you can substitute with a few wraps of insulation tape to hold it in place.
